This is param.h in view mode; [Download] [Up]
/*
* The standard Pcomm parameters. Everything can be altered by using one
* of Pcomm's menus. Although editing by hand is not encouraged, the
* pcomm.param file is just an ASCII file.
*/
#define MAX_CDELAY 120
#define MIN_CDELAY 10
#define MAX_PAUSE 120
#define MIN_PAUSE 1
#define MAX_TIMER 20
#define MIN_TIMER 2
#define NUM_PARAM 44
#define LINE_SET 0
#define TERM_SETUP 4
#define GEN_SETUP 10
#define DELAY_TIMES 19
#define ASCII_SETUP 21
#define LD_CODES 30
#define MACROS 34
struct PARAM {
/* 0-3 used in ls_menu() */
int d_baud; /* default baud rate */
char d_parity; /* default parity */
int d_dbits; /* default data bits */
int d_sbits; /* default stop bits */
/* 4-9 used in term_setup() */
int hot; /* the decimal code for the hot key */
char *ascii_hot; /* ascii representation of hot key */
char *d_duplex; /* default duplex */
char *flow; /* flow control */
char *cr_in; /* send as carriage return */
char *cr_out; /* receive carriage return as */
/* 10-18 used in gen_setup() */
char *logfile; /* default log file */
char *dumpfile; /* default screen dump file */
char *strip; /* strip high bit (translate table) */
char pause_char; /* pause char synonym */
char cr_char; /* carriage return char synonym */
char ctrl_char; /* ctrl char synonym */
char esc_char; /* escape char synonym */
char brk_char; /* modem break synonym */
char *abort; /* destination of aborted downloads */
/* 19-20 used in gen_setup() & delay_times() */
int c_delay; /* connect delay time */
int r_delay; /* redial delay time */
/* 21-29 used in axfer_setup() */
char *lecho; /* echo locally? */
char *expand; /* expand blank lines? */
int cr_delay; /* carriage return delay (ms) */
char *pace; /* pace the output? */
char *cr_up; /* send carriage return as */
char *lf_up; /* send line feed as */
int timer; /* transfer timeout */
char *cr_dn; /* receive carriage return as */
char *lf_dn; /* receive line feed as */
/* 30-33 used in d_revise() */
char *ld_plus; /* + long distance code */
char *ld_minus; /* - long distance code */
char *ld_at; /* @ long distance code */
char *ld_pound; /* # long distance code */
/* 34-43 used in macro() */
char *mac_1; /* shifted 1 macro */
char *mac_2; /* shifted 2 macro */
char *mac_3; /* shifted 3 macro */
char *mac_4; /* shifted 4 macro */
char *mac_5; /* shifted 5 macro */
char *mac_6; /* shifted 6 macro */
char *mac_7; /* shifted 7 macro */
char *mac_8; /* shifted 8 macro */
char *mac_9; /* shifted 9 macro */
char *mac_0; /* shifted 0 macro */
char *p_path; /* path to the pcomm.param file */
};
#ifndef MAIN
extern struct PARAM *param;
#endif /* MAIN */
These are the contents of the former NiCE NeXT User Group NeXTSTEP/OpenStep software archive, currently hosted by Netfuture.ch.