This is csna.41.04 in view mode; [Up]
Path: digifix!not-for-mail From: Conrad_Geiger@NeXT.COM (Conrad Geiger) Newsgroups: comp.sys.next.announce Subject: MEETING: October Meeting of the Minnesota NeXTSTEP User Group Date: 5 Oct 1993 00:17:32 -0400 Organization: Next Announcements Lines: 58 Sender: sanguish@digifix.com Approved: sanguish@digifix.com Message-ID: <28qsgs$2tg@digifix.digifix.com> Announcing the October meeting of the Minnesota NeXTSTEP User Group: Date: Tuesday Evening, October 12th Time: 7pm - 10pm Location: Geometry Center University of Minnesota Topic: "Getting Started With DriverKit." Speaker: Peter Eisch U of Minnesota and Etude Engineering Food: Cookies and Drink will be provided AGENDA: Terry Trover of Tech Components will be demoing an Elographics Intellitouch touch-screen monitor. Peter Eisch will discuss what the new NEXTSTEP documentation tries to convey and then present psuedo-code that describes how an interrupt driver can handle the interrupt and do I/O with the board. DIRECTIONS The Center is in Suite 500 of the "Old FMC building" (now clearly marked University of Minnesota) which 6 stories tall, has red stripes, and is located at 1300 South Second Street. The building is just north and east of the Minnesota Supercomputer Center which is in the northwest corner of the intersection of Washington Avenue and I35W. I35W southbound: take the Washington Avenue exit, turn right at the stoplight, go 1 block, turn right, go 1 block, turn left, go 1/2 block and you will find the building on your right. I94 eastbound: exit onto 35W northbound, immediately take UofM exit as in I35 northbound. I35W northbound: take UofM exit, specifically the 3rd Street branch, turn left at the stoplight, go 2 blocks, turn right, go 1 block, turn right, go 1 block, turn left and you will find the building on your right. I94 westbound: take the Riverside Avenue exit, turn right, go to Cedar Avenue, turn right, follow Cedar as it curves to the left and turns into Washington Avenue. Cross the bridge and make the first right, go 1 block, turn right, go 1 block, turn left and the building will be on your right. Once you reach the building, pull into the driveway, and drive to the visitor lot, mention that you are "visiting the Geometry Center" an the guard should open the gate and let you in. Come into the building, ride an elevator to the 5th floor, turn right, go through the glass double doors, turn left through the next set of glass double doors, walk down the hall until you can turn sharp right into the classroom where we'll be meeting. Call Scott Bertelson at 626-8303 if there are any questions about the facility.
These are the contents of the former NiCE NeXT User Group NeXTSTEP/OpenStep software archive, currently hosted by Marcel Waldvogel and Netfuture.ch.