This is GNU-emacs-18.53-on-Masscomp,-Next in view mode; [Up]
Date: Sun 25-Jun-1989 10:53:33 From: Unknown Subject: GNU emacs 18.53 on Masscomp, Next Two items: 1) I've just finished installing GNUemacs 18.53 on our group of Masscomps (RTU 4.0; 5700,5400s & 5520s) with absolutely no problems; just use the ucb universe and make it with the provided m-masscomp.h & s-rtu.h after setting up the local paths. I just remembered 1 extra thing I had to do; compile everything BUT loadst in the ucb universe. When compiled in ucb loadst always says you have new mail; it works fine when compiled in the att universe. 2) Now, we've also got a single Next on our network and I'd like to bring up 18.53 on it (0.9 comes with pre-compiled 18.52) so we have the same version running on everything. Also a lot of us here have vt100-style terminals and like to use edt-emulation; the goldkey code is broken in 18.52 but works fine in 18.53. (Of course, this applies only when rlogin'g in to the Next; the keypad is dumb on the Next console). Does anyone have m-next.h and s-mach.h for this version on a 0.9 Next? If need be we can write them ourselves, but I'd rather not have to spend the extra time to figure out the special stuff needed for the Next, especially since Next already knows it. Thanks, rick Rick Gray uucp:{uunet,shell,rice}!soma!rick Department of Neurology Internet: rick@soma.neuro.bcm.tmc.edu Baylor College of Medicine Houston, Tx 77030 >From: ali@polya.Stanford.EDU (Ali T. Ozer)
These are the contents of the former NiCE NeXT User Group NeXTSTEP/OpenStep software archive, currently hosted by Marcel Waldvogel and Netfuture.ch.